Electrogalvanized shaft wire direct is in the plating tank through the current one-way to gradually plating zinc on the metal surface, the production speed is slow, the coating is uniform, the thickness is thin, usually only 3-15 microns, the appearance is bright, poor corrosion resistance, generally a few months will rust. Compared with hot dip galvanizing, the production cost of electric galvanizing is lower. The difference between cold galvanizing and hot galvanizing: the difference between cold galvanizing and hot galvanizing is that the amount of zinc is different, and they can be identified from the color, and the color of cold galvanizing is shiny silver white with yellow. Hot dip galvanizing shiny white.
According to the introduction of galvanized iron wire factory, galvanized iron wire is the selection of excellent low carbon steel, through drawing forming, pickling rust removal, high temperature annealing, hot galvanizing, cooling and other processes. Galvanized iron wire should pay attention to the following points during use:
① The diameter of galvanized iron wire for drawing shall not be less than 4mm, and the diameter of galvanized iron wire for binding shall not be less than 2.6mm.
② Electrogalvanized shaft wire direct sales shall not be used for waist band compression reinforcement, usually not used for all binding.
③ The galvanized iron wire shall not be damaged when twisted.
④ Prevent the operation method of using more than two strands of galvanized iron wire to wrap around at one time.
Post time: 24-01-24