Floor heating mesh and floor heating pipe is an important part of the whole floor heating system. If the floor heating mesh has problems, it will directly lead to the floor heating can not be used, so it is necessary to understand some maintenance knowledge of the floor heating mesh. If the indoor temperature is lower than 5℃ after the equipment of floor heating system, all the water in the system should be blown out by air compressor to prevent the system from freezing.
The initial heating of the floor heating network should be carried out under the guidance of the technical personnel of the floor heating equipment company, and put into use without debugging. The water supply temperature of the low-temperature hot water floor radiant heating system should be 35-50℃, not more than 60℃, and the working pressure of the heating system should not exceed the annual winter when the geothermal heating system is enabled.
Must be strict in accordance with the rules of the heating process cycle gradually, can not be one step in place. Floor heating mesh can be cleaned every year before the use of the filter at the front of the water distributor, to ensure that the water pipe is clean, to prevent blockage of the pipeline specific methods are as follows: to close the inlet and backwater valve connected with the pipe; Then open the filter, remove the filter and clean clean, check whether the filter is damaged, blocked, such as damage should be replaced with the standard filter, according to the original package can be.
Floor heating mesh in the beginning of water supply or use process, air may accumulate in the pipeline, affecting the heating effect, then you can open the discharge valve of the water collector, the gas is discharged, the above is the relevant content of the floor heating mesh for us, hope to help us.
Post time: 22-09-21