When the iron wire factory uses galvanized iron wire to bind the strengthened goods, the corresponding binding method should be selected according to the fastening node status of the strengthened goods, such as opening binding, opening binding, inserting binding and so on. The insulation layer of semi-rigid and soft insulation products should be based on the diameter of steel pipe and the size of equipment and steel pipe. The width of galvanized iron wire or glue is bound together, the width is 60mm, and the binding interval of semi-rigid insulation products shall not exceed 300mm; The larger length of felt and cushion shall not exceed 200mm, and the number of belts shall not be less than 2.
The insulation layer of galvanized iron wire and hard thermal insulation products can be tied with double galvanized iron wire. The binding interval is not more than 400mm, and the pipes or corresponding equipment with a nominal diameter equal to or greater than 600mm should be stopped after binding, and the galvanized steel wire surrounded must be winched. Tighten iron or wood rods, but the tightening level should be moderate, not too tight or too loose, nor damage the steel wire. Galvanized wire is made of low carbon steel wire, is made of low carbon steel, after drawing molding, pickling rust removal, high temperature annealing, hot dip galvanized. Cooling process and other processing.
Post time: 27-09-21